A, way to clarify
Input mode of the rv precision planetary reducer can be divided into: the hole type, shaft type, extended type worm shaft; Hole type reducer output mode can be divided into: output, one-way output shaft, the bi-directional output.
Second, the basic functions
1, worm speed is less than or equal to 1400 RPM;
2, center distance rv25, rv30, rv40, rv50, rv63, rv75, rv90, rv110, on a total of 9 rv130;
3, single speed ratio is 7.5, 10, 15, 20, 25, 30, 40, 50, 60, 80, 100, a total of 11 kinds of speed ratio;
4, reducer can be positive and reverse direction operation.
Three, installation,
1, according to practical request a variety of installations, six surface can be installed;
2, installation must be strong and reliable;
3, prime motor and reducer operating institutions shall earnestly to, negligence shall not be greater than the allowable compensation of coupling used;
4, after installation rotation with the hand, must be flexible, no card lag phenomenon.
Four, the use of smooth oil exchange
1, the first time to use, or exchange of worm gear and worm reducer machine operation 150-400 hours after the exchange of smooth oil, oil change period is less than or equal to 4000 hours in the future;
2, regularly check the oil quantity and quality, keep smooth enough oil, timely exchange mix impurities or change of oil;
3, note oil amount is to be prepared in accordance with the table at the request of a mixture of different brand of oil to stop, a mixture of same brand but different viscosity oil allow;
4, deceleration machine working environment temperature for - 40 ° C ~ + 40 ° C, when the environment temperature is below 0 ° C, before starting smooth heat necessary to 0 ° C above or smooth oil with low freezing point.
Fifth, pay attention to matters
1, shall not be gravity hammer reducer shell, prevent damage;
2, regular maintenance, seal, shaft, etc can normal installation foundation;
3, such as normal use, smooth oil of the highest temperature should be less than 85 ° C. Oil [litres of abnormal changes, produce the phenomenon such as abnormal noise, it is necessary to stop the machine immediately to check, exclusive problem, after the main sustainable use;
4, exchange of new spare parts required by the running-in and load test before formal application.
